What should be done when using the blow molding machine?


How to use the blow molding machine to make it more con […]

How to use the blow molding machine to make it more convenient and simple to extend the life of the blow molding machine?

1. When people use the blow molding machine, they should carefully check the power supply, control system, heating system, etc. of the blow molding machine, whether they are in normal condition, and for the part that needs to increase the lubricating oil, it is necessary to increase the amount of lubricating oil to ensure The normal operation and operation of the equipment.

2. When using the blow molding machine, the mold should be accurately installed on the blow molding machine. Check whether the button has been in the precise orientation, and also need to start according to the requirements of the rules. The machine is operated and operated under normal conditions.

Blowing machine specific steps

1. When operating the blow molding machine, the preform should be placed in the preform container, and then in the machine through the transport device will actively enter the active positioning device according to the preform, and then the bottle embryo mouth up , loaded onto the preform holder and fed into the drying tunnel.

2. After passing the heating, the preform will be sent to the blowing channel for clamping, and after passing through the low pressure and high pressure blowing, the gas is removed, and finally the mold is opened, and the person can be from the channel of the full active blowing machine. Take the molded bottle off.